ZAPI Group – ZTP Srl

it | en

Accessories

Smart console

With this console it is possible to interact with the controller via CAN or Serial communication in order to monitor the real time operation and to change the software parameters in order to better fit the application.

Battery level indicator

This device is used for indication of battery capacity.

Multifunction digital indicator (mdi)

This indicator provides three main functions: battery state of charge indication, hour meter count, and information about the alarm status of the system. The MDI PRC indicator implements same functions as MDI.

Eco smart display

This electronic module is an intelligent operator interface. The graphic display informs the operator of the truck status in real time (BDI, HCs, operating modes, fault control). The Navipad is the interactive interface for operators and service engineers to interact with truck,setup and calibrate truck sensors.

Sicos

This electronic module is an intelligent operator interface. The graphic display informs the operator of the truck status in real time (BDI, HCs, operating modes, fault control).

Smart display

This electronic module is an intelligent operator interface. The display informs the operator of the truck status in real time (BDI, HCs, operating modes, fault control). The membrane keypad is the interactive interface for operators and service engineers to customize truck setups and calibrate truck sensors.

Graphic smart display

This electronic module is an intelligent operator interface with large viewer area. The graphic display informs the operator of the truck status in real time (BDI, HCs, operating modes, fault control).

Mhyrio cb

Mhyrio CB is an electronic module specifically designed for the control of hydraulic electrovalves. Tipically it is one of the nodes in an intelligent distribution system in wich different modules are connected via canbus.

Mhyrio flash

Mhyrio flash is an electronic module specifically designed for the control of hydraulic electrovalves. Tipically it is one of the nodes in an intelligent distribution system in wich different modules are connected via canbus.

Hydraulic valves controller (hvc)

HVC is an electronic module specifically designed for the control of hydraulic electrovalves. Tipically it is one of the nodes in an intelligent distribution system in wich different modules are connected via canbus.

CAN tiller & CAN encoder

Designed to collect inputs and make them available via CAN in order to minimize the wiring

VCM - Vehicle Control Master

The VCM family is a group of I/O and valve controlles also including the vehicle control software capability. Depending on final application requirements different sets of I/O are available. Also available in double micro and/or double CAN architecture.