This is a compact and cost effective steer by wire controller for 24/48V trucks fitted with AC steering motors up to 500W. It is suitable for handlebar and tiller trucks. Microprocessor technology,combined with the CAN Bus communication system, provides an effortless steering command facility.
- Steering sensitivity reduces when the truck speed increases.
- Truck speed reduces in proportion to the angle of the steered wheel.
- A non-linear relationship between the handle bar position and the steered wheel angle can be made.
- On request, the steering command may originate from a remote unit via CAN Bus meeting the requirements of EN954-1: Category 3 Standard.
Nominal voltage: 24V, 36V, 48V
- EPS AC0: 50A (45A@48V)
- EPS AC0 WG: 70A
Dimensions: 120x150x55 mm
Dual Microprocessors, both CAN Bus connected
Environmental Protection: IP54 or IP65 (with Ampseal connector)